Page 18 blueplanet Installation Instructions 1502x - 5002x
Figure .: AC-connection
AC Connections are a or wire connection. In wire
systems incorporating a Neutral there will be the follow
-
ing connections; Line-, Line-, Neutral, and Ground. In
wire systems not incorporating a Neutral there will be
the following connections; Line-, Line-, and Ground.
We recommend the following conductor cross-sections
for cable lengths up to feet:
– blueplanet x: AWG up to AWG
°C Copper Wire
– blueplanet x: AWG up to AWG
°C Copper Wire
– blueplanet x: AWG up to AWG
°C Copper Wire
– blueplanet x: AWG up to AWG
°C Copper Wire
Larger cross-sections should be used for longer leads.
NOTE
Use Copper Conductors only.
The following AC over-current protection must be used
for the installation of the inverter.
– blueplanet x → A Breaker
– blueplanet x → A Breaker
– blueplanet x → A Breaker
– blueplanet x → A Breaker
. Electrical connection
General information
The electrical connections can be established after the
inverter is installed in its xed location. Knockouts are
provided on the sides, bottom, and rear to easily run
conduit to the desired locations.
NOTE
Only conduit pipes according to UL B can be used.
!
WARNING
Inputs and output circuits of this unit are isolated from the
enclosure. System grounding must be done in accordance with
the National Electrical Code (NEC), ANSI/NFPA and is the
responsibility of the installer.
You must adhere to all mandatory safety regulations,
the currently required technical connection specica
-
tions of the responsible power supply company, as well
as to other generally applicable regulations.
!
WARNING
To connect the inverter, the AC and DC sides must be discon-
nected from all power sources and secured against being
inadvertently energized.
(A) Grid Connection
AC- connection
(see Figure 5.13)
Figure .: Connection of the blueplanet
Section 5 · Installation and Start-Up
/13(
N L1 L2 PE
Commentaires sur ces manuels